VCT Vision ELITE Series Guide de l'utilisateur télécharger pdf (Page 12)

Firewire Connector Mouse (above) and Keyboard (below)

Connectors

LAN/Ethernet ( above) and USB (below)

Connectors

VGA Connector

Parallel Port Connector Digital Monitor Connector

Video Output Line Out

Line In Microphone

Serial Port.

Power

The Elite Series unit should be plugged into a UPS (Uninterrupted Power Supply).

ATTENTION

The correct voltage should be selected on the Voltage Selection Switch before plugging the

power cord of the Elite Series unit into a three-pin plug in outlet.

Monitor

The Elite Series may be connected to a standard analog computer monitor via the VGA

connector, a digital monitor via the Digital Monitor connector or to a standard security

television using composite output via Video Output

. Make sure that the monitor is also

connected to an adequate power supply receptacle – preferably it should also be connected to

the UPS.

Real Time Monitor

Additionally, the Elite Series has an extra output (Video Output Connector) for a real-time

video monitor. The connector for this output is located next to the Video Input

Connectors.

Keyboard/Mouse

Connect the keyboard and mouse to the Keyboard and Mouse connectors on the rear

panel of the Elite Series unit.

Cameras

The cameras should now be connected to the BNC connectors on the rear of the Elite

Series unit.

The camera positions are clearly marked next to each connector. Depending on the model

being used, there are four or sixteen inputs to the Elite Series unit. If you are using less than

the maximum number of cameras, it is preferable to connect them starting at position 1 and

working up consecutively to the last camera position.

Elite Series – Secure Access Video Surveillance

User Guide and Installation Manual

Page 12 of 48 Pages

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 47 48

Pas de commentaire

VCT Vision ELITE Series Guide de l'utilisateur Page 12